Hello,
we have a problem with the update from 5.0 to 5.5
We have to locations and on every location is one vCenter Server with 5.0 installed. Both locations are in link mode.
Now we did the following steps:
- we updated location 1 wirth 5.5 (simple install) and all works fine
- we updated location 2 with 5.5 (simple install - i know this was a fault because we need the link mode) and we get an error that the server can not isolated from the link mode and the installation was canceld
- we set back our snaphshot and did it again, this time with manuall installation and select the third option (this option is needed if link mode is used - according to the documentation)
- we still get the error that the server can not isolated from the link mode.
I think there are some corrupted data in the active directory lightwight directory because we did some wrong steps during the update. Is it possible to delete the wrong entries in the active directory lightwight or what is the best practise to get the update with link mode done?
Thanks for your help.